Reduce the risk of chipping by using a low-pressure pierce of approximately 10,000 psi.
Reduce low-pressure piercing time from two minutes to 10-15 seconds (depending on thickness) by cutting a tiny circle rather than leaving the jet fixed on one spot.
120 grit garnet will produce the best edge quality. If speed is your priority and chipping not a concern, use 80 grit garnet
Cut at 75,000 PSI to increase cut speed by 50-75% and improve edge quality.
Support glass on a sheet of 3/16” corrugated PVC rather than directly on the metal slats. This reduces the risk of chipping and fogging.
If your projects require you to frequently raise and lower pressure, install a patented Jet Edge dual pressure valve to save time and prolong waterjet pump component life.
