Energy efficient and economical, Jet Edge’s ECO-JET direct drive waterjet pump produces up to 1 GPM of 55,000 psi ultra-high pressure water for precision waterjet cutting and surface preparation applications. Like all Jet Edge products, the ECO-JET features Jet Edge’s signature rock-solid construction for lasting performance.
Advantages
- Energy-efficient and eco-friendly – Uses up to 40% less electricity than a 50hp pump, but produces same output!
- Economically priced without sacrificing quality.
- Easy to maintain.
- Powers any manufacturer’s waterjet system!*
* Waterjet table or tool must be capable of sending a pressure relief signal to the pump.
Specifications
-
Power: 30HP (22kw)
-
Output Pressure: 55,000 psi (3800 bar) continuous
-
Flow Rate: 1 GPM (3.8 L/min)
-
Maximum Orifice: .015 in (.38 mm)
-
Power Supply: 3-Phase, 460 VAC (60Hz), 35AMP
-
LWH: 50 inch x 32 inch x 46 inch (1270 mm x 820 mm x 1170 mm)
-
Weight: 1500 lb (680 kg); approximate
Standard Features
-
High-efficiency TEFC motor
-
1800 nominal motor speed (rpm)
-
User serviceable attenuator to reduce pressure fluctuations
-
Liquid-filled pressure gauges
-
UHP safety shielded tubing
-
U/L, CU/L listed industrial control panel
Environmental
-
Ambient Room Temperature: 50°-95° F (10°-35° C)
-
Relative Humidity: Non condensing, maximum 95% at 95ºF (35ºC)
Electric Motor
-
Motor Output: 30 hp (22 kw)
-
Motor Type: High Eciency TEFC electric motor
-
Full load current: 35A @460VAC (60 Hz)
-
Requires a voltage/frequency option kit to match local electrical requirements.
Low-Pressure Water
-
Supply Requirements:
Coolant Water: 4 GPM (19 lpm)
Feed Water: 4.5 to 5 GPM (17-19 lpm)
Minimum pressure 60 psi (4.2 bar)
Maximum temperature 70ºF (21ºC) -
On-board filtration to 0.45 micron
-
Type: Pretreated, <100 TDS, PH 6-8, Silica <15PPM
